Kit Includes (one each):
The Magic Module™ (ELK-MM443) is a four analog or digital input, four relay output programmable logic controller (PLC). It may be used as a stand alone field programmable controller in a vast array of applications from timers, door controllers, simple process controllers, multiple zone security controls, etc. or as a networked controller with up to 31 other modules connected on a common RS-485 data bus. The Magic Module™ is programmed by a personal computer. The program is stored into re-programmable Electrically Erasable Programmable Read Only Memory (EEProm memory). The ELK-MB485 is the interface used to transfer the program from the computer the Magic Module™.
- Magic Module™ (ELK-MM443S)
- Data Bus Interface (ELK-MB485)
- ELK Code Editor / Application Writer Software
- 12 Volt D.C. Plug-in Power Supply
- 9 pin Serial Port Cable
- RS-485 Data Bus Ribbon Cable
- Cable to program ELK-MM220 modules
- Instruction Manual
The ELK-MB485 is used to communicate between a personal computer and an ELK-MM443 Magic Module™ Programmable Controller, 4 input, 4 output, iButton™ and X10® interface. The ELK-MB485 converts the computer's RS-232 Serial Data to RS-485 Data which is used by the ELK Magic Module™ series of products. This allows programs to be downloaded into the Magic Modules. Input and Output status can be displayed and controlled from the computer.
The ELK-P1216 is a general purpose 12 Volts D.C. Switching Plug-In Power Supply. It is ideal for alarm, access control, and CCTV applications requiring up to 1.5 Amps. The power pack plugs into 100 to 120 volts A.C., and supplies regulated 12 volts D.C. to a standard 2.1mm power plug.